System-sensor PDRP-2001 Manual do Utilizador descarregar pdf (Página 106)

106 PDRP-2001 Series Manual — P/N 53043:E1 2/28/2011

Circuit Mapping and Cross-Zoning Input-to-Output Circuit Mapping and Cross-Zone Operation

A.1.2 Mapping Input Zones to Release Circuits for Cross Zone

Activation

Using the OUTPUT CIRCUITS menus, this fire panel will allow you to assign a release circuit type

of operation to any two of the four output circuits. Up to two releasing circuits (or hazards), called

RELEASE 1 and RELEASE 2, may be created. Input zones may be assigned in various ways to

activate either one or both of the release circuits. The fire panel treats RELEASE 1 and RELEASE

2 functions independently from each other, although they may share input circuits for activation.

Cross-zoning is set up in the CROSS INPUT ZONES menus, where you can create up to three

groups of input zones for each release circuit. When cross zone groups have been set up, the

OUTPUT CIRCUIT MAP associated with the input zones will automatically show YES for release

output circuits. This extremely flexible cross-zone with grouping capability is used in the

following examples.

Example 3: A single hazard, cross-zoned application using two smoke detector input zones and

one releasing output circuit. Input Zones 1 and 2 are cross-zoned to activate output circuit 2, which

is programmed as a RELEASE 1.

• Output Circuit 1 is programmed as alarm NAC using the OUTPUT CIRCUITS menus.

• Output Circuit 2 is programmed as Release Circuit 1 using the OUTPUT CIRCUITS menus.

• Output Circuit 3 is programmed as alarm NAC using the OUTPUT CIRCUITS menus

• Output Circuit 4 is programmed as supervisory NAC using the OUTPUT CIRCUITS menus.

• Either of smoke detector Input Zones 1 or 2 will directly activate Output Circuit 1 (Alarm

NAC).

• Smoke detector Input Zone 2 will also directly activate Output Circuit 3 (Alarm NAC) but not

Output Circuits 2 or 4.

• Smoke detector Input Zones 1 and 2 are cross-zoned (both must be in alarm) to activate Output

Circuit 2 (Release 1) but not Output Circuit 4.

ZONE 1 TYPE

1=2-WIRE SMOKE

2=2-WIRE HEAT

3=N/A

OUTPUT MAP ZONE 1

1=ALARM NAC YES

2=RELEASE 1 YES

3=ALARM NAC NO

OUTPUT MAP ZONE 1

1=SUPV BELL NAC N/A

REL 1 CROSS GROUP 1

1=ZONE 1 YES

2=ZONE 2 YES

3=ZONE 3 NO

OUTPUT MAP ZONE 2

1=SUPV BELL NAC N/A

ZONE 2 TYPE

1=2-WIRE SMOKE

2=2-WIRE HEAT

3=N/A

OUTPUT MAP ZONE 2

1=ALARM NAC YES

2=RELEASE 1 YES

3=ALARM NAC YES

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 147 148

Comentários a estes Manuais

Sem comentários

System-sensor PDRP-2001 Manual do Utilizador Página 106

Comentários a estes Manuais